triple slider card

A Triple Slider Fun Fold card is a fun way to show off the pretty On the Horizons DSP (#157768).

Measurements:

Blackberry Bliss CS 5 1/4″ x 11″
scored at 1 3/4″ and 3 1/2″ rotate 180
degrees and score again at 1 3/4″ and 3 1/2″
Sentiment matte 1 1/2″ x 2″
Fresh Freesia (1) 4 1/4″ x 5 1/2″
(1) 3″ square
Basic White CS (1) 3 3/4″ x 5″
(1) 2 3/4″ square
(1) 1 1/4″ x 1 3/4″
Designer Series Paper 3 3/4″ x 4 7/8″ cut into
three pieces 3 3/4″ x 1 5/8″

Score and burnish the four score lines on the base card. See photo below.

Add two lines of tape in the upper left corner – see pictures below)

Add one of the 3 3/4″ x 1 5/8″ on the top corner and then add tape to the bottom left on the same side as the top slider.

Place the two opposing sides together and there will be an open spot on the right panel and add adhesive.

Add the third 3 3/4″ x 1 5/8″ piece to the middle in between the top and bottom pieces.

Add the Basic White 3 3/4″ x 5″ to the middle base of the card.

Add adhesive to the back of the card base. Then add to the center of the Fresh Freesia 4 1/4″ x 5 1/2″ layer.

When cutting the Designer Series Paper – keep in order. Add the middle DSP piece in the center of the middle slider.

Add the top piece of DSP to the top slider but position it closer to the bottom of the Blackberry Bliss cardstock piece. even on the top and sides but closer to the middle piece of DSP than perfectly centered.

Add the last bottom piece of DSP closer to the top of the bottom slider cardstock – even on the sides and bottom but positioned closer to the middle piece of DSP.

stamp the sentiment pieces – I added the square pieces on the middle inside of the base piece and the smaller rectangular piece to the right hand edge of the middle slider – see photos below.

This card slides open and creates a 3 Dimensional card that can stand on it’s own. Fun, fun, fun! Try this and make some fun stamp art of your own – one stamp at a time!

Happy Stampin’

Natalie