torn dsp card inspiration

I wanted to show you all a copy of the card that inspired Wednesday’s torn DSP card. Unfortunately like I said in the post the other day I cannot give proper credit because when I tried to go back to find the inspiration card post I could not find it.

This is the same technique I used for Wednesday’s card only using the Nature’s Walk Suite of Products and it makes a gorgeous Masculine card!

Measurements:
BASE:Early Espresso CS: 5 1/2″ x 8 1/2″
scored at 4 1/4″
Basic White CS: (2) 4″ x 5 1/4″, scrap for die
cutting
DSP: different 4″ strips of coordinating DSP
does not need to be from the same package

Die cut the larger leaf die from the Nature’s Symphony die set out of the lower right-hand corner of one of the 4″ Basic White layers.

Cut a smaller square from the Stylish Shapes dies set from a Basic White scrap for the sentiment piece. I stamped the You Make Me Smile in Early Espresso on the square die and blended the edges with a Blending Brush.

Tear strips from the 4″ DSP pieces about 1/2″-3/4″ wide.

Adhere to the other 4″ x 5 1/4″ Basic White layer as done in Wednesday’s post.

Cut a 1″ strip off gthe left-hand side of the torn DSP layer.

Adhere the 1″ strip to the left-hand side of the die cut Basic White layer.

Since this die is more intricate, turn over the layer and glue all around the leaf cut out and the right hand side of the die cut layer to adhere the other DSP piece to that side. Place the DSP layer DSP facing what will be the front and make sure that the DSP is the same pattern direction as the 1″ strip before securing it down. This creates the illusion of the DSP flowing through the paper!