I saw a similar card the other day and loved it so this is my version I colored the dies a little differently than the sample I saw – I wanted to imitate the reflections of the sun on the water on the dies.

This Scenic Coast DSP is so gorgeous anything you do with it elevates the project to next level!

Measurements:
BASE: Strawberry Slush CS: 5 1/2″ x 8 1/2″
scored at 4 1/4″
DSP: 6″ x 6″
Basic white CS: 5 1/2″ x 8 1/2″ for die cuts,
4″ x 5 1/4″
Crumb Cake CS: 2 1/2″ x 4′

Die cut the Rolling Waves water dies from the 5 1/2″ x 8 1/2″ Basic White layer – two of the largest wave pieces, one of the starfish and shells and 1 each of the smaller foam wave pieces.

Cut the 6″ x 6″ DSP piece at 4″ and then again at 5 1/4″.

Place the larger die diagonally on the DSP 4″ x 5 1/4″ layer with the foamy tendrils facing upwards and the top left hand edge at the horizon. Angle it downwards to where you can see a lot of the sunset reflections on the water and mark under the die on the DSP two points on either edge. (This will be your cut marks so make sure that the DSP will be long enough to be covered by the die.)
Cut the DSP on the diagonal from the high mark on the left hand edge to the lower mark on the right hand edge.

Adhere the diagonal cut DSP to the Strawberry Slush base card.

Cut a piece of Crumb Cake to fit in the lower portion of the card under the DSP diagonal cut.

Stamp the piece with the sand background stamp and the speckles stamp.

Adhere to the bottom of the card front.

Place the die pieces over the DSP and visually mark where the sunset colors would be reflected on the water and color the dies with Secret Sea on the outside edges and Strawberry Slush and Timid Tiger under the sunset reflections to continue that reflection into the water dies.

Adhere the dies on the diagonal over the sand and DSP.

Blend Strawberry Slush and Timid Tiger with blending brushes over the shells and starfish dies and adhere in the foam and seaspray of the wave dies.

I first adhered the orangy Sunset Sparkle Sequins to the card front and I decided I wanted a more subtle sparkle so I replaced them with the white irridescent sparkle sequins.
Do you agree?
Do you like the colored sequins or the white ones shown at the end?

I stamped the bottom of the 4″ x 5 1/4″ Basic White layer with Crumb Cake sand image and adhered a shell over the sand.

I adhered the 4″ x 3/4″ leftover DSP to the top and stamped the Happy Birthday sentiment from the Rolling Waves stamp set in Strawberry Slush ink to the middle of the layer.

Adhere to the inside of the card base.

I added the White irridescent Sunset Sparkle Sequins to the outside of the card first three and then added two more!

I am very pleased with the final project!
Now it’s your turn to create some artwork of your very own – one stamp at a time.