more color mondays – blueberry bushel, berry burst, and crushed curry

Today’s More Color Monday color challenge was a bit of a mistake I picked the colors and had a card deign in mind using the Homemade Sweetness Designer Series Paper but these colors do not directly appear in the DSP color listing. I had already announced this color challenge last week and did not want to change anything so I went with it! Hopefully this will show you all that even if you do not have all the colors that are in the DSP you can still design cards that work well with the Paper!

I saw this fun fold design on a fellow demonstrator’s website that is in my sideline and she is super creative always an inspiration – thanks Susan C.

This fun fold is called the Peek Through Diamonds fun fold and although I used cut outs from the DSP that were a little larger than I wanted and you cannot see the peek through as I intended my card turned out OK – sometime a card you design is just not your favorite! And that is ok – some one will love it!

Measurements:
BASE: Crushed Curry CS: 5 1/2″ x 11″
cut off 2″ score at 1″, 1 1/2″, 2″, 6 1/4″, 6 3/4″
and 7 1/4″
Blueberry Bushel CS: 1/4″ x 5 1/2″, (3) 1 1/8″
squares
Berry Burst CS: 1 7/8″ x 5 1/2″ embossed
(3) 1 1/4″ squares
DSP: 1 3/4″ 5 1/2″, and 2″ x 5 1/2″ and scraps
for cut outs
Basic White CS: (3) 1″ squares

Mount the three Basic White squares to the Blueberry Bushel squares and then mount to the largest Berry Burst squares.

Cut the Base cardstock at 2″ to make the base 5 1/2″ x 9″. Score at 1″, 1 1/2″, and 2″ to make an accordian fold on the left side of the card base and then score at 6 1/4″, 6 3/4″ and 7 1/4″ to make an accordian fold on the right-hand side of the card.

Lay the 2″ piece on the right-hand side for spacing purposes and adhere the blueberry bushel gingham DSP to the opening on the inside of the card base.

The flap on the right-hand side of the card will be on the inside of the card – it looks like it is the outside piece but it is not.

Adhere the DSP to this inside flap.

Decide which cut outs to place on top, middle and bottom of the diamonds and then adhere glue dots on the back of each side point of the diamonds.

Place the 2″ Crushed Curry layer that you cut off of the base card over the DSP flap and adhere the glue dots one to the left hand flap and to the 2″ layer on the right-hand side. Line up the top of the diamond with the top of the inside of the card so it does not stick out further than the card dimensions.

I decided the right-hand flap looked to plain so I added the Berry Burst layer and embossed it with the Ladybug Picnic 3D embossing folder.

Adhere the other diamonds first to the sides of the card, then to the one above or below with glue dots.

I added a small strip of Blueberry Bushel CS to the left-hand flap to add more color.

I added three Pearlized Faceted Circles to the card for a little sparkle! The card is complete!

Try this fun fold it’s easy and with a fun peek through to see more of your Designer Series Paper. Now go and create some artwork of your very own – one stamp at a time!

Happy Stampin’
Natalie