celebrate spring february 2026 paper pumpkin alternate pop up card

We were asked to bring an alternative Paper Pumpkin card to OnStage 2026 and this is my submission. Part of joining together at convention is to share ideas and it will be fun to see the creativity that will be on display. At the end of this post I will have some photos of some of the other submissions on display!

Measurements:
BASE: Pretty in Pink CS: 4 1/4″ x 11″
scored at 5 1/2″
Various pieces from the Celebrate Spring
February 2026 Paper Pumpkin
Chip Board

I used the card front from card #3 in the February 2026 Paper Pumpkin CXelebrate Spring kit and cut it down to 4″ square.
Stamp the bottom edge of this 4″ square layer with the Happy Easter from the Celebrate Spring stamp set in the kit in Shy Shamrock ink (also provided in the Paper Pumpkin kit)

I placed Stampin’ Dimensionals on it to pop it up to be able to put a slide mechanism underneath it.

I cut pieces of chip board I have saved from the packages of 12 x 12 papers I have purchased over the years.
I cut 2 pieces of each of these sizes: 1/2″ x 3 3/4″ and 1/2″ x 2″, and glued the smaller sections to the front and back of the bunny die cut from card #1 in the kit.
I adhered one of the longer pieces to the top edge of the 4″ square.

I removed all of the release papers from the four Stampin’ Dimensionals on the back of the 4″ square and placed Tear-n-Tape to the backside of the chip board, slip the bunny under the top chip board bar, remove the release paper from the Tear-n-Tape and adhered the square to the bottom of the card front.
(I later realized that I needed to place another piece of chip board at the bottom of this piece to stop the bunny from falling out the bottom! So you should do this step now instead of waiting for my fixing of my oversight LOL)

I cut a strip of 1/2″ x 6″ Pretty in Pink cardstock and slid the bunny all the way up and adhered this strip to the bunny’s back. This will be the pull mechanism to slide the bunny up and down to “pop” out of the Easter Basket!

At this point as I was moving the mechanism for the bunny I realized there was not a bottom stop point and that the bunny could be pushed below the card front piece so I lifted up the 4″ square and adhered another piece pf chip board to the bottom edge of the 4″ square to have a stopper for the slider mechanism!

I decorated the card front with the Easter Basket die from card #3 and the eggs die cut from the same card, i adhered it above the printed flowers so that the edges of the eggs were covering the top of the square.

I cut a banner edge on the Pretty in Pink strip that is the slider mechanism and wrote PULL on the slider tab!