fern & flora torn edge card – card sketch #125

Today’s new card sketch is a fun one and this is the card I designed with it – let me see what you can do with it!

Measurements:

BASE:Secret Sea CS: 5 1/2″ x 8 1/2″
DSP: 2″ x 5 1/4″
Basic White CS: 1/2″ x 5 1/4″ strip, 3″ x 5 1/4″,
scraps for dies
Old Olive CS: scrap for die
Mossy Meadow CS: scrap for die
Berry Burst CS: scraps for dies

Take the 3″ x 5 1/4″ layer and emboss in the Fern and Flora 3D Embossing folder.

Attach to the right-hand side of the Secret Sea card front leaving an even border on the top, bottom and right side.

Tear the DSP in half and flip one side over.
Tear the edge off of the Basic White strip, adhere one side of the DSP to the left of the embossed layer then the Basic White strip and then the other side of the dsp leaving the same size even border on the top, bottom and left hand side.

Die cut the ferns in Old Olive scrap and Mossy Meadow scrap, die cut the flower sections and the moth in Berry Burst scraps.

Start to adhere the ferns over the embossed section.

Adhere the Old Olive lacey fern over the Mossy Meadow larger fern.
Adhere the Berry Burst flower sections together and glue the White flower centers in the middle of the flower pieces.
Stamp the sentiment in Berry Burst ink onto the sentiment die and blend Berry Burst ink over the surface of the die.

Pop up the sentiment piece over the bottoms of the fern dies and adhere the flowers diagonally onto the sentiment piece.

Pop up the die cut moth over the fern die cuts.

I placed the smaller flower die in the ferns and three Mossy Meadow embellishments around the sentiment from the Natural Matte Dots.

What a fun layered card using this easy card sketch – what will you make from this sketch? Let me know! Now it’s your turn go and create some artwork of your very own – one stamp at a time!

Happy Stampin’
Natalie