unbounded beauty diagonal gate fold card

Gate Fold cards are pretty cool and there are so many variations! This one is called a diagonal gate fold card and I used the Unbounded Beauty Designer Series Paper to make this one!
One of the things I absolutely LOVE about our designer series paper (besides the fact that is the most gorgeous paper made) is that the A and B sides coordinate so well! Check out today’s project to see how easy things come together!

Measurements:
BASE: Petunia Pop 4 1/4″ x 5 1/2″ piece,
3″ x 4″ for front sentiment matte
Designer Series Paper: 5 1/4″ x 12″
scored at 2″, 4″, 8″ and 10″
2 3/4″ x 3 3/4″ for front layer
Basic White scrap for sentiment die

Score the DSP at 2″, 4″, 8″, and 10″. Fold into a mountain fold at 2″, valley fold at 4″ and 8″ and mountain fold at 10″.
Focal piece

On the two side panels mark lightly with a pencil at 2″ from the top of the DSP on each side.

Place the 2″ pencil mark into the cutting track and angle the paper so the first score line is also in the track and cut a diagonal line from pencil mark to top of the paper at the score line.
Do this on each side.
Save the triangle pieces.

The top of the gate fold will show the exposed backside of the second panels where the triangular piece was cut away – it will look like this.

Switch the triangles and adhere to the opposite bottom corners.

Adhere the DSP piece to the Petunia Pop 1/4 sheet of cardstock as the base, making sure that the edges are an even amount.

Adhere the small DSP rectangle to the 3″ x 4″ petunia Pop cardstock matte.

From a Basic White cardstock scrap cut a die from the Unbounded Love die set and choose a sentiment (the sentiments from the coordinating set are awesome but I used a sentiment from Something Fancy because I have a niece graduating from Georgetown with a dual MBA and Law degree and this was made specifically for her! I also used the hatchmark image from the Spotlight on Nature for the edging of the sentiment piece then popped it up on Stampin’ Dimensionals and placed it in the center of the DSP focal piece.

Place adhesive only on the back of the left hand side (if you adhere both sides the card will not open!)

Adhere to the center of the left hand panel.

I decided to add a pocket on the inside for a gift card or cash for the graduate!
I cut a scrap of Petunia Pop to 2″ x 3 7/8″ and adhered Tear-n-Tape to both sides and bottom.

I adhered the pocket to the bottom of the inside middle panel!

I took a scrap of the unbounded Love DSP and fussy cut the flowers from that small piece (use them all even the half flowers use them on the edges of the paper!)