Measurements:
BASE: Basic White CS: 4 1/4″ x 11″
scored at 5 1/2″
Pretty Peacock CS: 4 1/4″ x 5 1/2″, 3 1/2″ x 4 1/2″
for the leaf die
Vellum CS: 2″ x 5 1/4″, scrap for circle die
DSP: 4″ x 5 1/4″ 1 1/2″ x 4″

I adhered the 4″ x 5 1/4″ DSP to the Pretty Peacock layer.

I adhered the 1 1/2″ piece of DSP to the front of the vellum and then I could add adhesive under the DSP to attach both pieces.

Attaching Vellum can be tricky because it is translucent. Because you can partially see through the material that means you usually can see the mode of adhesion too!

TIP: There are several ways around this!

1. Hiding the adhesive under non translucent paper attached to the vellum as I did in this example!
2. Hiding glue dots under wisely placed embellishments!
3. Adding Multipurpose liquid glue with a sponge or Q-tip to the entire back of the vellum
4. If you emboss vellum it creates a pattern and makes the vellum white and a little less translucent making it easier to hide adhesive as you will see I did to attach the sentiment piece!

I die cut a circle around the sentiment from the Spotlight on Nature dies and using a silicone mat I squeezed a dollop of Multipurpose Liquid Glue onto the silicone matte and applied glue around the embossed edges of the circle die where it is less likely to show and attached the die to the center of the card above the leaf die and DSP layer.

Then glue the layer onto the card front.

I added one larger and one small on either side of the sentiment piece and then added the last small one to the dot on the “i” in “smile”.

Which do you like better?

Try adding vellum to your cards for an elevated and elegant look – now go and create some artwork of your very own – one stamp at a time!

Happy Stampin’
Natalie

REMINDER: the SNEAK PEAK items in the Nature Walk Suite Collection and the Balmy Blue Gingham ribbon are only available to demonstrators and in starter kits until January 6th so there will not be photo links below until they are released.