Today’s More Color Mondays color challenge card contains a technique I have shown before with a little twist!

I love white on white cards with a slash of color – and up north we are receiving a lot of the white stuff so I was in need of a SLASH of color!

Measurements:
BASE: Basic White CS: 4 1/4″ x 11″
scored at 5 1/2″, (2) 4″ x 5 1/4″ layers,
1/2″ strip scrap

Yep that is it supplies are minimal but the results are a WOW!

Take the two Basic White CS layers and die cut one with the Textured Notes rectangular dies – I used the fourth largest rectangle.

Save the die cut for another use as we will be using the negative die as a mask.

Take the other layer and emboss using the Stampin’ Cut and Emboss machine with Base Plate #1 and Embossing Plate #4 and the Sunflower 3D embossing folder.

I used my glass mat and taped the mask over the embossed layer – securing them down so they don’t move.

I burnished Crushed Curry ink with a blending brush in a strip down the right side of the inside of the masked portion of the layers.

I burnished Pumpkin Pie ink with a blending brush in a strip down the middle of the inside of the masked portion of the layers.

I burnished Real Red ink with a blending brush in a strip down the left side of the inside of the masked portion of the layers.

Normally when I do a White Wash technique I drag the Craft White ink pad over cardstock to create the Whitewashed look but I did not want to drag my white pad over bright ink colors and corrupt the white pad. The craft ink would have re-wet the colored ink and destroyed the ink pad so I took my palette knife and made an ink slurry with Craft White re-inker and water (you can use a Stampin’ Spritzer to wet the ink) then mixed and spread it on an acrylic block with the flat bottom of the palette knife.
I then dragged the palette knife over the Sunflower embossed surface to give the tips of the petals a white washed effect!

Remove the mask and reveal your lovely layer!

I used a Basic White 1/2″ strip scrap and stamped the “just because” sentiment from the Blooming Phrases stamp set and colored it with the residual ink left on the blending brushes in the same order as done on the card!

Adhere the layer to the card base and adhere the sentiment piece on Stampin’ Dimensionals for some added depth and dimension!

Add some Basic Rhinestone Jewels to the card to finish it off with a little sparkle and this simple but stunning card is complete!

Imagine the possibilities – use any shape and make a mask and color inside the negative space!

Now go and try this technique and make some artwork of your very own – one stamp at a time!

Happy Stampin’
Natalie