more color mondays – barely blush, balmy blue and soft sea foam

more color mondays – barely blush, balmy blue and soft sea foam

I love this new Artisan Sketched Garden Designer Series Paper and apparently everyone else does too as of the end of this week it is back ordered but we have a new notification system so if you love these cards – put your email and name down to be notified as soon as they return!

I love black and white – something about the contrast that is just intoxicating – so striking!

This paper has so much possibility!

Measurements:
BASE: Barely Blush CS: 5 1/2″ x 8 1/2″
scored at 4 1/4″
DSP: 1″ x 5 1/2″, and scraps for the vases.
Balmy Blue CS: 1/2″ x 5 1/2″
Soft Sea Foam CS: 2″ x 5 1/2″
Basic White CS: scrap strip for the sentiment

I gathered the Light and Dark Stampin’
Blends for all three colors in this challenge: Barely Blush, Balmy Blue and Soft Sea Foam and colored an entire line of the vases from one of the Artisan Sketched Garden DSP.

I fussy cut some of the vases out to use on the cards.

I adhered the Balmy Blue strip under the bottom edge of the DSP strip and adhered both to the Soft Sea Foam layer. I adhered the three layers to the center of the card front.
I stamped the Basic White strip with a sentiment and Blended it with a Blending Brush and Barely Blush ink.
I piked out three vases and adhered them across the designer series paper and colored cardstock strip section alternating height.

I fussy cut some of the small flowers on the scraps of the opposite side of the vase DSP and adhered them to the bottom of the card front below the vases.

I adhered more little flower fussy cuts to the top edge of the card front.
I popped up the sentiment piece with Stampin’ Dimensionals over the vases.
I added two Barely Blush 2026-2028 In Color Dots embellishments to finish off the card with some coordinating soft pearlescent bling!

Try a soft color combination with your next stampin’ project – now go and create some artwork of your very own – one stamp at a time!

Happy Stampin’
Natalie

Here is another card I made using these same More color Monday color challenge colors!
I used a new embossing folder in the background called Floral Spray 3D embossing folder also currently unavailable this was a popular item also! It will be back in stock soon if you have to have it!
more color mondays – petal pink, balmy blue and soft sea foam

more color mondays – petal pink, balmy blue and soft sea foam

Today’s More Color Mondays color challenge features Petal Pink, Balmy Blue and Soft Sea Foam.

Today’s card features a very fun and sparkly technique – dyed Wink of Stella.

Measurements:
BASE: Balmy Blue CS: 4 1/4″ x 11″
scored at 5 1/2″
Soft Sea Foam CS: 4″ x 5 1/4″
Petal Pink CS: scraps for dies
Basic White CS: scraps for dies

Always keep your Wink of Stella pens even when they dry out. If you unscrew the brush top and pry the black stopper out of the pen shaft you can fill the shaft with alcohol to re-wet the glitter left in the barrel. Put the black stopper back in and screw the pen top back in. Squeeze the tube to release the glitter inside onto a silicon mat. Squeeze one drop of ink refill onto the silicon mat. Mix the drop of ink refill with the glitter.

Cut the largest Spotlight of Nature dies in the Soft Sea Foam CS layer. Paint the edges of the die with the Soft Sea Foam tinted Wink of Stella glitter.

After painting the edges of the die place it back inside the layer.
Mix another squeeze of glitter with Petal Pink ink refill.

Splatter the Soft Sea Foam layer with the Petal Pink tinted glitter.

Adhere the Soft Sea Foam layer to the balmy Blue card base.
Stamp two flowers on Petal Pink CS in Petal Pink ink and paint the petals with the tinted Petal Pink glitter.

Die cut a smaller Spotlight on Nature die in Basic White CS. Stamp the “Sending HAPPY thoughts” from the upcoming Sending Salutations stamp set from the new catalog debuting on May 5th. Paint the word HAPPY in the Petal Pink tinted Wink of Stella.

Adhere the pink flowers to the Soft Sea Foam layer.

Mix more glitter from the Wink of Stella paint brush and a drop of Balmy Blue ink refill.

Paint the petals of the flower from the Gallery Bloom stamp bundle.

Paint the leaves with the Soft Sea Foam tinted Glitter.
Adhere the Pink flowers under the Balmy Blue flowers – pop up the blue flowers onto Stampin’ Dimensionals.

Adhere the sentiment under the blue flowers.

Adhere the Pearls of Beauty around the card.

Adding tint to the Wink of Stella adds beautiful sparkly glitter! Try this technique and create some sparkling artwork of your very own – one stamp at a time!

Happy Stampin’
Natalie

more color mondays – crumb cake, balmy blue and summer splash sneak peak

more color mondays – crumb cake, balmy blue and summer splash sneak peak

When I saw this stamp set in the Online Exclusives pre-order release I knew I would love it – I am a water baby and love the waves and the lake that I live on! So this set was perfect. These are coming in the new Online Exclusive product release in March – so this is a sneak peak!

This card is a center flap fun fold and so super easy but I LOVE the effect!

Measurements:
BASE: Crumb Cake CS: 4 1/4″ x 11″ scored at
5 1/2″ and cut from the score line down the
front from 1″ from either side.
Balmy Blue CS: 2 1/4″ x 4 1/2″
Basic White CS: 4 1/4″ length scraps for die cuts
2″ x 5 1/4″, scraps for the umbrella die cuts
DSP: 1 1/2″ wide scraps for beach towel

I stamped the water image on the Balmy Blue CS layer by stamping off first on my grid paper and then multiple times on the Balmy Blue to add motion and texture.

I used Balmy Blue ink and a blending brush on a scrap of 4 1/4″ wide Basic White CS.
I layered Summer Splash ink over the Balmy Blue blended area to add layers of color to the wave die.
I die cut the foam die out of Basic White CS and the wave area out of the blended Basic White colored cardstock.
I adhered the White foam to the blended area.
I adhered those wave pieces to the Balmy Blue stamped layer.
I cut the Crumb Cake base at 1″ from each side of the front of the card of the 4 1/4″ x 11″ cardstock base from the score line at the top of the card to the opening on the front section only.

I cut the wave layers to 4 1/4″ inches wide and then at 1″ from each side to create three piece.

I stamped the sand image on the three front panels of the card front in Crumb Cake ink just above where the waves will be adhered.
I adhered the three wave layers to the bottom of the card front panels.
I adhered the two side panels down to the back panel of the card.
I stamped the starfish on each corner in Crumb Cake ink and Happy Birthday sentiment in the middle in Summer Splash ink and adhered it to the middle in between the two wave panels.
I cut a 1 1/2″ piece from the Splash of Sparkles DSP and cut fringe on it end for the beach towel and saved a thin strip for the front sentiment.

I die cut the umbrella solid image in Basic White CS and the striped umbrella in Summer Splash and Basic White and alternately adhered the bands to the solid umbrella.

I adhered both to the middle front panel hanging off both sides being careful to only glue the center portions.

I stamped the sentiment on a thin strip of DSP and added it to the front.

I popped up the umbrella on Stampin’ Dimensionals on the left side only and therefore popped up the sentiment on the left side and glued it directly to the umbrella on the right side to make up the height differential.

Using the Stampin’ Blends alcohol marker Summer Splash Dark I colored five Iridescent Pearl embellishments for the card.
I adhered the pearls to the card front.
I adhered two clusters on the outside panels so you can see the pearls when the card is open and closed!
I love this simple fun fold and I LOVE this new stamp set.

Try this new stamp set when available or play with the ones you already own and create something today to warm up your day – one stamp at a time!

These stamps and dies will be released in the new Online exclusives release in March they are currently only available to demonstrators and in the starter kit so they will not be listed in the photo links below!

Happy Stampin’
Natalie

more color mondays – gorgeous grape, lemon lime twist and balmy blue

more color mondays – gorgeous grape, lemon lime twist and balmy blue

It’s another More Color Monday color challenge featuring three colors I love Gorgeous Grape, Lemon Lime Twist and Balmy Blue. I also LOVE this technique the Stampin’ Blends alcohol Vellum technique.

Measurements:
BASE: Basic White CS: 4 1/4″ x 11″
scored at 5 1/2″, scraps for the dies
Vellum: 3″ x 6″
Gorgeous Grape CS: 1/2″ x 5 1/2″, scrap for die
Balmy Blue CS: 1/2″ x 5 1/2″
Lemon Lime Twist CS: 1/2″ x 5 1/2″

Since Gorgeous Grape is such a dark color, so the Highland Heather Dark Stampin’ Blend is very close to Gorgeous Grape color.

I colored with the side of the Dark Highland Heather Stampin Blend paint brush on the vellum.

Spray the vellum with 99% alcohol from a Stampin’ Spritzer.
Dry the vellum with the Heat Tool and push the alcohol and ink color around until the alcohol evaporates.
Start coloring the vellum with other colors – one color at a time, spray the vellum with alcohol and push the color with the Heat Tool until the alcohol evaporates.

Repeat with different colors until you like the look of the vellum.

Stamp a sentiment in Versamark ink and sprinkle with the white WOW embossing powder. Heat with a Heat tool until the powder is melted.

Use the Three Banner Punch and punch out the sentiment piece.

Cut 2 sections of all three colors of CS in 1/2″ x 5 1/2″ and adhere them together so that you have two sections of three colors.
Use the three color sections and adhere to either side of the vellum.

Die cut the large leaf die from the Beautiful Motifs dies set from a Basic White CS scraps.

Adhere the vellum down with the colored CS strips.

Adhere the die to the top of the colored vellum.

Notice how the vellum is magnified by placing it on top of the Basic White CS!

I punched the sentiment with the middle section of the Three Banner Punch.

Pop up the sentiment banner over the die and the vellum.

Die cut the flowers from the Petals of Beauty and color them with a Blending Brush and Gorgeous Grape ink.
Stamp the flower dies with the background stamps from the Swirled Designs to add texture to the petals.
I placed the stamped and textured Petal dies and popped up the flowers around the sentiment piece.
I added three white pearls of Beauty to finish off this stunning alcohol vellum cards.

Try this cool technique but know that you need to use only 99% alcohol – regular isopropyl will not do the trick! Now go and make some really fabulous colored vellum – and add one stamp at a time!

Happy Stampin’
Natalie

snowflake kisses diagonal cut half card

snowflake kisses diagonal cut half card

I had a leftover from my studio Stamp-a-Stack class and instead of making another copy of the card I created for class I decided to redesign the card! Here is a fun diagonal cut card using the materials from Monday October 13th’s More Color Monday card post.

Measurements:
BASE: Highland Heather CS: 4 1/4″ x 11″
scored at 5 1/2″, scrap for snowflake die
Basic White CS: (3) 4″ x 5 1/4″
Balmy Blue CS: scrap for snowflake die
Pool Party CS: scrap for snowflake die

Place the card in the Stampin’ Trimmer diagonally and cut the front bottom of the card off.

Place the 2 Basic White layers 1/2 down from the top of the card. Cut two of the Basic White layers by laying them over the base card and marking the diagonal edges so the angle of the diagonal cut will be the same.

Die cut one of the two diagonally cut Basic White layers with the background die from the Snowflake kisses die.

Adhere the die cut to the other diagonally cut Basic White layer.

Adhere the double Basic White layer to the diagonal card base front.
Adhere the last 4″ x 5 1/4″ to the inside of the card.

Stamp the sentiment in the right-hand corner with Gorgeous Grape ink so it can be seen when the card front is closed.

Cut one each of the single snowflakes from the Snowflake Kisses die set in Pool Party, Balmy Blue and Highland Heather cardstock and adhere around the circle in the background die on the card front with Multipurpose Glue.
Adhere three Faceted Snowflake gems to finish the card.

This card uses most of the same products as the card I designed on 10-13-25 but looks very different – amazing what you can do with the same exact products but a different design!

Go out and create some artwork of your very own – one stamp at a time!

Happy Stampin’
Natalie