pleated prism fun fold

Inspiration can come from anywhere!

I often look at Pinterest, other demonstrators work and websites and Facebook and Instagram reels – this card popped up on my Pinterest board from a sideline demonstrator named Susan C. – thanks for the inspiration!

This card is called a pleated prism fun fold and starts with a 4″ square of DSP – grab one from your stash and follow along with me!

Measurements:
BASE: Old Olive CS: 4 1/4″ x 11 scored at 4 1/4″
scraps for two die cuts
Basic White CS: 4″ x 5 1/4″ and (2) 3 1/4″ x 5 1/4″
scrap for snowflake dies
DSP: 4″ x 4″

Emboss the three Basic White layers in the Forever Plaid 3D embossing folder.

Score the DSP piece at 2″ and then mark with a pencil at 3/4″, 1 1/2″, 2 1/2″, and 3 1/4″ on both the top and bottom of the DSP piece.

Score from the top mark at 3/4″ to the bottom mark at 3 1/4″.

Score from the top mark at 1 1/2″ to the bottom 2 1/2″ mark on the bottom.

Score from the top 2 1/2″ mark to the bottom 1 1/2″ mark.

Score from the top 3 1/4″ mark to the 3/4″ bottom mark.

Fold the score lines into a Valley-Mountain-Valley-Mountain-Valley so that the first middle and last scores are valley folds and the second and fourth lines are mountain folds. Use a bone folder to make all of the score lines crisp.

Using the Stampin’ Seal + and placing the tip of the fold on the center of the score line for the card base – run a line of tape from the Stampin’ Seal + on the outside flat edge opposite to the pointed edge – adhere the flat outside edge to the inside front of the card base.

Run a line of tape down the outside flat edge of the pleated prism DSP piece and close the back of the card base over the DSP mechanism. Rub on the outside of the card over where the tape is adhered to the card to secure the pleated prism DSP piece.

Take a scrap of Old Olive CS and stamp a sentiment from the Snowflake Kisses stamp set and die cut with the Textured Notes dies.

Die cut the line of small snowflakes from the Snowflake Kisses die set and place three Glue Dots on the die cut around the sentiment and adhere the snowflakes.

Take a second scrap of Old Olive and die cut the second largest square die from the Stylish Shapes die set and add some snowflake dies to the top corner.

Adhere the two 3 1/4″ x 5 1/4″ embossed layers on either side of the pleated prism DSP piece.

Adhere the Old Olive square die cut to the right hand side for a place to write.

Adhere the 4″ x 5 1/4″ embossed Basic White layer to the card front and pop up the Old Olive sentiment die piece in the center.

Add three Rhinestone Basic Jewels to the outside of the card to finish it off with a little holiday sparkle!

Try this easy fun fold with your stash and go create some artwork of your very own – one stamp at a time!

Happy Stampin’
Natalie