another designer series paper tri-fold card

Today’s blog post is another tri-fold using some of our beautiful Designer Series Paper! I had so much fun designing Wednesday’s tri-fold that I decided to go ahead and do another one!
Today we are using the Full of Life 6″ x 6″ DSP for this vertical tri-fold card.

Measurements:
BASE: Basic White CS: 4 1/4″ X 11″
scored at 4″ and 6 3/4″
(5) 4″ x 5 1/4″ for watercolor background die
cuts
scraps for the sentiments
DSP top layer: 3 3/4″ x 4″
DSP middle layer 2 1/2″ x 4″ mine is 2 1/4″ because this was a 6″ paper stack and I wanted to save paper.
DSP: bottom layer 4″ x 4″

Using an acrylic block ink up one color per watercolor wash. I used Azure Afternoon, Lemon Lime Twist, Crushed Curry, Poppy Parade and Gorgeous Grape. Add ink directly to the acrylic block and spritz with water in a Stampin’ Spritzer. Add the paper on top of the block and hold in place for a few seconds to allow the paper to absorb the water and the ink. Die cut one of the leave stems from each watercolor died paper.

Score the 4 1/4″ x 11″ Basic White cardstock at 4″ and 6 3/4″.
Cut the desired DSP – I wanted a color gradient so i chose the B sides of the Full of Life DSP.
I adhered the top layer of 3 3/4″ x 4″ to the top panel.

I adhered the middle DSP layer of 2 1/2″ x 4″ to the middle panel.

I adhered the Bottom DSP layer of 4″ square to the bottom panel.
Just think of the possibilities if you used a scenic 12″ x 12″ DSP you could create a continuous scene across the card and do this in either landscape of vertical!

I adhered the leaf dies to each panel close to the corresponding color gradient on the DSP.

I die cut the word friend from Basic White scraps and added it to the top of the bottom panel so that the word does not peek out when the card is closed and is a surprise!

I die cut 2 of the rectangular strip dies for the top 2 panels and stamped sentiments in Azure Afternoon ink for the top panel and Crushed Curry for the middle panel.