sale-a-bration triangle tri-fold card

I found this fun fold, the triangle tri-fold on the internet and loved the look. Thought the new Sale-a-bration level two reward Wonderful World stamp set and coordinating DSP would be perfect for this type of card!

Measurements:
2 pieces of Starry Sky cut to 10 1/4″ x 8″ scored at 5 1/2″
1 piece of Wonderful World DSP cut at 3 3/4″
square and cut on the diagonal
2 pieces of Coordinating Wonderful World DSP
cut to 3 3/4″ x 4″
scrap starry sky and Basic White CS for the
sentiment pieces

Cut a piece of Starry Sky cardstock to 10 1/4″ x 8″. On the short side cut the cardstock in half at 4″.

Score both of these pieces at 5 1/2″ on the long side. On the side of the cardstock that measures 4 3/4″ on each cardstock piece, make a mark at 4″ and score diagonally to the outer corner.

Flip one piece over and attach to the other piece of cardstock matching up and gluing over the 5 1/2″ area. (You should have a triangle to the top left and a triangle to the bottom right when you are finished.)

Cut a piece of Designer Series paper to 3 3/4″ x 3 3/4″ Cut in half on the diagonal. (Keep in mind which way the pattern is going and make sure that the triangle pattern is going the correct direction for the finished card.) Layer these pieces onto the card base.

Cut two pieces of patterned paper to 3 3/4″ x 4 1/4″. Fold up the card base and fold the top triangle back. Lay the patterned paper as shown. Using a pencil make a mark about 1/8″ from the diagonal score line (about 9/16″ from the top).

Using your paper trimmer cut the patterned paper at an angle from the opposite corner to the pencil mark. Do the same with the other piece. Note that this piece will be opposite.

Prepare a focal panel for the card that will center between the two triangles on the front, and a panel for the inside of the card.

I used Stampin’ Write markers direct to rubber to color the flower image from the new level two Sale-a-bration set. For the sample, two layered circles were die cut, one in white and another in Starry Sky cardstock. The white circle was stamped with an image from the Wonderful World Sale-a-bration Stamp Set.

For the inside cut and stamp a piece of white cardstock to 3 3/4″ x 5 1/4″.

Adhere the stamped Image to the coordinating background circle. Wrap a piece of ribbon 24″ long around the card so that the ends are to the right hand side of card.

Add glue/adhesive to the half of the Circle image that lays on the top triangle and glue down over the ribbon to card. Add new 2022-2024 In Color Matte Decorative Dots embellishments to the card front as desired.