pull out flap card – elegantly said

This pull out flap card features the Elegantly Said stamp set (#155095) and the Simply Elegant Specialty Designer Series Paper (#155761), Copper Foil (#142020) sheets and the Layering Circles Die set (#151770)

Measurements:
Smoky Slate Cardstock (#131202) 5 1/2″ x 8 1/2″
scored at 4 1/4″
4″ x 4″ piece for die cutting
Basic White cardstock (#159276) 5 1/4″ x 8
scored at 4″ and 2″
4″ x 4″ piece for die cutting
Simply Elegant Specialty DSP 5 1/4″ x 4″
a complimentary pattern 2 pieces 1 3/4″ x 3
3/4″
Copper Foil 4″ x 4″ piece for die cutting
I used the largest scalloped circle die and the 2nd and 3rd to the largest plain circle dies

Fold the Basic White cardstock and crease with a bone folder as shown in picture. Adhere large panel to the inside back of the card base.

Adhere the 5 1/4″ x 4″ piece of DSP to the outside of the card using glue only around the edges so you can use the die cuts separately if desired.
Cut the largest plain circle in the upper middle third of the card front.

With the 4″ x 4″ Smoky Slate cardstock and the copper foil cut the largest plain circle first and then position the scallop circle equidistant on all sides on the circle.

Adhere these “window frame” pieces around the circle cut out of the card.

Cut the 4″ x 4″ Basic white square with the smaller of the two plain circles – decorate it and mount onto the copper circle cut out when you made the “window frame” (I embossed the flower image from the Elegantly Said stamp set in Copper Embossing Powder.
Mount the two 1 3/4″ x 3 3/4″ pieces of DSP to the two smaller sections of the Basic White cardstock and then with the card front closed place Tear&Tape on the visible part of the flap DSP through the circle and mount the embossed circle onto the flap.