getting the most out of your designer series paper

When you cut your Designer Series Paper efficiently it can go a long way! And this card is a perfect example of that efficiency!

I cut the 6″ x 6″ Subtle DSP from four sheets in half at 3″ and then at 1/2″, 3/4″ and 1″ sections depending upon the color, stretching the amount of cards you can do with just a few sheets of paper!

Measurements:
BASE: Basic White CS: 5 1/2″ x 8 1/2″
scored at 4 1/4″
Layer: 3″ x 5″
Basic Black CS: 4″ x 5 1/4″
DSP: 3″ x 1/2″, 3″ x 3/4″, 3″ x 1″
Lemon Lolly CS: 3″ x 1 1/4″

On the long 5 1/2″ side, rub the upper edge of the paper with an embossing buddy from the embossing accessories kit. Stamp the Wishing open sentiment in Versamark and sprinkle with the White embossing powder and heat set with the Heat Tool until melted.
Adhere to the Basic White card base, this will have the wishing turned to a vertical position.

Adhere the top strip of DSP to the 3″ x 5″ Basic White layer, leaving an even border on the top edge.
Then adhere the bottom strip, leaving an even 1/4″ border on the edge.

Stamp the open script YOU on the Lemon Lolly CS and adhere to the center of the Basic White layer.
Then adhere the remaining two pieces of DSP in the spaces in between the Lemon Lolly and the top and bottom DSP pieces. This will help get even spacing.

Wrap some Basic White Twine around the top portion of the 3″ x 5″ Basic White layer and tie in a knot.
Adhere this layer to the right of the embossed Wishing sentiment on the Basic Black CS layer.

Pick your coordinating sentiment and stamp on the Soft Seafoam DSP.

What a fun way to use some of your Designer Series Paper! Try this easy card design and let me see what you create!

Now go and make some artwork of your very own – one stamp at a time!

Happy Stampin’
Natalie