birthday secret message slider card

Did you like decoder rings when you were little or secret messages like the ones with invisible ink? This card is a throwback to the those fun days! This is a Secret Message Slider Card featuring the Swirls Designs stamp set and the new Online Exclusive Splash of Sparkles Specialty Designer Series Paper.

Measurements:

BASE: Timid Tiger CS: 4 1/4″ x 5 1/2″
3 3/4″ x 4 1/4″, 2 1/2″ x 5″
Pretty In Pink layer: 5 1/4″ x 8 1/2″, scored at
2 3/4″ and 6 3/4″
DSP: 2 5/8″ x 5 1/8″, 1 5/8″ x 5 1/8″
Basic White CS: 2 3/8″ x 4 7/8″, 3 1/4″ x 4 1/8″

I stamped the circle image from the Swirled Designs stamp set in Timid Tiger ink to the two Basic White CS layers as shown.

Then I used the splatter image, the Enjoy the Ride and the Happy Birthday from the Boardwalk Fun stamp set in Versamark and heat embossed with Gold embossing powder and the Heat Tool.

I actually stamped the Enjoy the Ride on the 3 1/4″ piece after I photographed it – it will be the secret message you will see at the end!

With the 3 3/4″ side at the top of the 3 3/4″ x 4 1/4″ piece, score at 3/8″ for the inside slider piece.

Adhere the Basic White layers to the Mattes of Timid Tiger making sure that the score is on the left hand side of the smaller piece.

Score the Pretty In Pink cardstock layer at 2 3/4″ and 6 3/4″.

Adhere the 2 5/8″ x 5 1/8″ DSP piece to the inside left panel.

Adhere the 1 5/8″ x 5 1/8″ DSP piece to the outside right hand panel.

Add two small pieces of Tear-n-Tape to the upper and lower edge of the inside of the right side panel as shown in the photograph.

With the small tab to the left of the 3 1/4″ x 4 1/8″ adhere the Basic White stamped layer to the 3 3/4″ x 4 1/4″ Timid Tiger piece to the right of the score line.

Add a piece of Tear-n-Tape along the length of the inside slider piece on the 3/8″ tab to the left of the score line.

Place the inside slider piece to the right hand side of the score line. Peel off the release paper for the Tear-n-Tape.

Fold the front panel down over the slider piece.

Adhere the front stamped panel to the outside of the first panel.

]Open up the first panel and bend the slider piece back towards the inside of the card and use a bone folder to secure the Tear-n-Tape and crease the score line.

Remove the release paper of the two smaller pieces on the last panel.

Fold the right panel over the left hand edge of the slider piece and rub the areas where the Tear-n-Tape is to secure the panel over the slider mechanism.

Now as you open and close the front left hand panel the slider mechanism will slide in and out to reveal you message – cool right?

Just like when you where a little kid create one of these cards and send a hidden message to one of your favorite childhood playmates to remind them of all the fun you used to have as kids!