artfully layered corner pop up fun fold card

Looking for an easy and different card to make and send out to someone special! This corner pop-up fun fold is just the ticket – easy and provides a fun pop up WOW factor as you open the card!

Measurements:
BASE:
Misty Moonlight 5 1/2″ x 8 1/2″
scored at 4 1/4″
Basic White 5 1/4″ x 4″ cut at a diagonal
scrap for the sentiment piece
Evening Evergreen scraps for die cut and
sentiment layer
DSP – I used a scrap of New Horizons for some
added green texture to the dies

Using a pen or pencil make a very small tic mark 2″ on either side of the 4 1/4″ score line.

Then fold the card inside out and make a tic mark 3″ down directly on the score line (mark from the same side you marked the 2″ marks)

PLace the tic marks on the cutting track of your Stampin’ Trimmer and using the lighter gray scoring blade, place the scoring blade on the tic mark at the score line and score from the 3″ tic mark to the end of the paper at the 2″ tic mark.

Do that on both sides of the score line – this will make three score lines converging at the middle score line at the 3″ mark – looks like a triangle with a line down the middle.

Fold the middle score line as a mountain toward the inside of the card and the two outside score lines in a valley fold.

Lay the Basic White cardstock on the card front and make a tic mark on the top right hand side of the layer 1/8″ from the angled fold and make a tic mark along the right side of the layer 1/8″ below where the angle meets the right edge of the paper and then cut both pieces with this diagonal cut.
Adhere one to the inside of the card.

Decorate the Basic White layer for the card front.
I stamped the open leaf stamp from the Artfully Layered stamp set and cut some leaf dies to decorate the front and inside pop up feature.

When adhering your pop up feature only place glue or adhesive on the portion of the die that will be attached to the bottom triangle and lay it flat face down on the card base and close the card and rub where the adhesive is to secure the pop up die cut to the angled pop up feature.

Adhere the front Layer to the card front and adhere the die cuts.

I layered a sentiment onto the card front and added Genial Gems for a little extra sparkle. I did two versions of this card – pictures are shown below of both versions.