hostess gift – christmas tags and holder

It is the holiday season and you will probably be invited to holiday dinners and parties and this is the season for hostess gifts as well!

This little Christmas tag holder is the perfect little hostess gift for those sweet celebratory occasions!

Follow along today to learn how to make this sweet gift ensemble for your holiday outings.

Measurements:
BASE: Cherry Cobbler CS: 6″ x 8″
scored at 3 1/2″ and 4 1/2″
Mossy Meadow CS Pocket layers:
(2) 3 1/2″ x 5 1/2″
scored at 1″ and 1 1/2″ on the 6″ side
scored at 1″, 1 1/2″, 4″ and 4 1/2″ on 8″ side
Mossy Meadow CS Belly Band:
1 1/2″ x 11″
scored at 1 3/4″, 3″, 6 1/2″, and 7 3/4″
DSP: (2) 2″ and 2 1/4″ and 3 1/4″ x 5 3/4″
scraps of Basic White and Night of Navy CS
for the Belly Band

Score the 2 pocket layer in Mossy Meadow
at 1″ and 1 1/2″ on the 6″ side and at 1″, 1 1/2″, 4″ and 4 1/2″ on 8″ side.

Cut a slightly diagonal slice inside the second score line on the 8″ side up to the first score line on the 6″ side.

Cut another diagonal slice on the opposite side inside the 4″ score line up to the first score line on the 6″ side.

Cut along the first score line on the 6″ side to the diagonal cuts on both sides.

Cut four small cuts at the 1″, 1 1/2″, 4″ and 4 1/2″ up to the second score line

Place Tear-n-Tape in the first two and last two sections as shown in this picture below.

Place two small pieces of Tear-n-Tape on the tab on the opposite side of the pocket as the last four pieces were placed – as shown in the picture below!

Fold the score lines so that the four pieces of Tear-n-Tape are on the outside and remove the release paper off the four pieces and fold the smallest tab under the outside tabs on both sides – it will look like the picture below!

Adhere the longer tab in between the two score lines on the middle tab so it looks like the picture below.

Remove the two pieces of Tear-n-Tape on the middle tab.

Adhere the flap of the middle tab over the two sides – like the photo below.

Turn the box to the side with the slot and place four pieces of Tear-n-Tape down the two sides of the slot.

Remove the release paper to the four pieces of Tear-n-Tape and adhere the pocket to the bottom inside of the two outer panels of the Cherry Cobbler base.

Adhere the two smaller pieces of DSP to the pockets and now you can load your tags into the pockets!

Score the belly band and place Stampin’ Seal + to the smaller edge.

Place around the closed tag holder and adhere the belly band tight enough to not fall off but to be able to slide off with ease!

Decorate the belly band.

I used the Christmas Word Collage hybrid embossing folder for some of the tags this is a Last Chance product and a great item to have in your collection!