gift card slider fun fold

Today’s post is a little late but as they say better late than never, right? Some days you just get tied up with unforseen duties!

This gift card slider fun fold is worth the wait though!

Measurements:
Summer Splash CS: 5 1/2″ x 8 1/2″
scored at 4 1/4″
Basic White CS: (2) 4″ x 5 1/4″, scraps for
stamped sentiment and word die
Lemon Lolly CS: 2 3/4″ x 3 3/4″, 1 1/2″ x 6″
scored at 2″ and 2 1/2″
DSP: 3″ x 4 1/4″,2 1/2″ x 3 1/2″

Take one of the 4″ x 5 1/4″ and stamp the circle image from the Swirled Designs bundle in Summer Splash randomly around the layer.

Adhere to the card base.

I stamped the second 4″ x 5 1/4″ piece with one circle image and added it to the inside of the card.

Take the larger DSP layer and die cut a hole in the center I used one of the sentiment dies from the Words of Beauty die set.

Turn the DSP layer over and place Stampin’ Dimensionals around the perimeter with the exception of under the die cut hole.

Attach the smaller DSP layer to the Lemon Lolly matte piece.

Score the 6″ long Lemon Lolly layer at 2″ and 2 1/2″. Then add a piece of Tear & Tape between the two score lines. On the back side of the smaller section add another piece of Tear & Tape to the top edge.

Fold the Tear & Tape piece of cardstock so both score lines are resting against the back of the Lemon lolly layer at the middle top edge.
Remove the backing from the Tear & Tape and attach.

Slide the long edge through the die cut hole and remove the second piece of Tear & Tape.

Lay the Lemon Lolly matted DSP piece in the center of the bottom piece of DSP and rub over the area where the Tear & Tape will attach.

I die cut the word because from the Words of Beauty die set in three matching colors and adhered them together.

I die cut the long sentiment die and inked up the It’s Your Birthday in Summer Splash and stamped it on the die.

I adhered Stampin’ Dimensionals to the sentiment.

I die cut the intertwined circle die in Vellum and attached it to the back of the long sentiment piece then adhered both the words and sentiment piece to the outside card flap.

I added a punch to the bottom of the pull tab piece and added some Darling Duckling ribbon.

I added a matching gift card to the inside upper edge of the pull tab.

I added five Shades of Green Hexagons for the embellishments!

Pull the tab and reveal your gift card so stinkin’ cute and what a fun way to present the gift card!

Try this tutorial and make this slider gift card holder with your supplies – now go and create some artwork of your very own – one stamp at a time!

Happy Stampin’
Natalie